Xhorse Condor XC-Mini Plus Cut HON66GP Key in Mins

Xhorse Condor XC-Mini Plus supports to cut a HON66GP key by bitting codes in minutes. Since I have the original bitting codes, it’s easier to cut key in this way.


Firstly, fix a key blank to be cut on clamp, press

Find bitting >> HON66GP >> Confirm >> Input bitting codes: 211351, 241351 >> Cut

xhorse-condor-xc-mini-plus-cut-hon66gp-key-in-mins-1


Condor XCMini machine will start cutting.

Just wait until stopped, approximately 1-2 minutes...

One side cutting was finished.


Take out the key to compare.

Its bittings are same as the key displayed.

The cutting result turns out to be neat & accurate.

xhorse-condor-xc-mini-plus-cut-hon66gp-key-in-mins-2

If you go on to cut the other side, just repeat operations as previous.


It’s said upgrade version Condor XC-MINI Plus II is coming. If you’re looking for a latest Xhorse smart Key Cutting Machine, then it’s worth considering.

www.xhorse.co.uk

Comments

Post a Comment

Popular posts from this blog

Xhorse HU162T 8-Cut/9-Cut/10-Cut Add Key & AKL Tutorial

Image
Today we'll show the procedure before using the Xhorse Key Cutting Machine to complete the add key and all key lost for HU162T 8-cut, 9-cut, and 10-cut keys. The tutorial applies to machines such as Dolphin II , Condor XC-MINI Plus II , etc. How to distinguish the HU162T 8-cut, 9-cut & 10-cut key? As shown in the picture, the 8-cut has only 1 fixed cut on the side and is straight. The effective surface is on the top. The 9-cut has 3 side cuts, and the effective surface is on the top. The 10-cut has 4 side cuts, and the effective surface is on the bottom. The operation process is demonstrated as follows.  HU162T 8-Cut Add Key Enter Xhorse App: Cut by Bitting >> HU162T >> Silca - HU162T >> 8-1 Bitting Read the prompts on the screen, and put the original key on the clamp according to the prompts. Click "Decode key". We can select the A-axis or B-axis options in the upper left corner. Switch to the B-axis key bitting page, the cut of the B-axis is fixe...
Read more

Solution: Xhorse Condor XC-MINI Plus 2 Movement Abnormal

Image
Xhorse Condor XC-MINI Plus 2 is making strange noises and abnormal movements? Learn how to diagnose and fix XYZ axis motor issues. Test sensors, replace faulty Y/Z-axis parts, and know when to call support. Quick solutions for smooth operation. Condor II Fault Phenomenon: Abnormal noise during XYZ axis self-check or movement after power-on. Noise occurs during key decoding/cutting when a specific axis moves. Solution Steps: Perform Device Self-Test: Navigate to: Motor Measurement → Test XYZ axes separately. Normal Result: "OK" displayed (no action needed). Fault Detected: "Bad" appears for the faulty axis (e.g., Y-axis in the example). Sensor Replacement: Y/Z-Axis Fault: Replace the faulty sensor (refer to the images for the locations of the old and new sensors). Image 1: Z/Y-axis sensor positions. Image 2/3:* Old vs. new sensor appearance. X-Axis Fault: Contact technical support (replacement is complex). Key Notes: DIY replacement recommended only for Y/Z-axis se...
Read more